Thermal conductivity against densityHigher and further left: spreads more heat for its weightThermal expansion against thermal conductivityLower and further right: warps less when heated
Try it on a partA bracket to run stress or thermal on, free in your browser
Sources4 documents: Cleveland-Cliffs, Carpenter Technology, U.S. Department of Defense, National Institute of Standards and Technology
Iron
Cleveland-Cliffs / AK Steel ARMCO Pure Iron Product Data Bulletin (07/2022): Table 1 typical physical properties, Table 2 typical mechanical properties after SRA/recrystallization anneal.
MIL-HDBK-5J, Metallic Materials and Elements for Aerospace Vehicle Structures (2003)U.S. Department of DefenseSteel AISI 4340 · Young's modulus (stiffness): MIL-HDBK-5J design value (AISI 4340, quenched and tempered)Steel AISI 4340 · Poisson's ratio: MIL-HDBK-5J design value (AISI 4340, quenched and tempered)
4
Elastic Properties of Metals and Alloys, I. Iron, Nickel, and Iron-Nickel Alloys, J. Phys. Chem. Ref. Data 2 (1973)National Institute of Standards and Technologyarchived copyIron · Poisson's ratio: NIST critically evaluated best value (polycrystalline iron)
Each number points to the document that states it, with the exact basis. Values without a number are computed from the sourced ones. "Not sourced" means no citable source states it (or only a specification minimum); figures computed from it are left out too.
Questions
Mechanical
Is Iron stronger than Steel AISI 4340?
Steel AISI 4340 is stronger: its yield strength is 1,035 MPa against 186 MPa for Iron (5.56x).
Which is lighter, Iron or Steel AISI 4340?
Steel AISI 4340 is lighter: 7,840 kg/m³ against 7,860 kg/m³ for Iron.
Which is stiffer, Iron or Steel AISI 4340?
Iron is stiffer: Young's modulus 207 GPa against 200 GPa for Steel AISI 4340, so the same part in Iron deflects less under the same load.
Which is lighter for the same job, Iron or Steel AISI 4340?
For the same stiffness or strength: Iron is lighter for a stiff rod or tie (tension), stiff beam (bending); Steel AISI 4340 is lighter for a strong rod or tie, strong beam, strong panel or plate.
Part that must be
Iron
Steel AISI 4340
Stiff rod or tie (tension)
lighter
3% heavier
Stiff beam (bending)
lighter
2% heavier
Stiff panel or plate
about equal
about equal
Strong rod or tie
5.58x heavier
lighter
Strong beam
3.15x heavier
lighter
Strong panel or plate
2.36x heavier
lighter
For the same stiffness or strength, mass scales with density over stiffness (or strength) raised to a power set by how the part is loaded: 1 for a rod in tension, 1/2 for a beam in bending, 1/3 for a panel (the standard material-selection indices).
Which is more ductile, Iron or Steel AISI 4340?
Iron stretches further before it breaks: 38% elongation at break against 18% for Steel AISI 4340.
Thermal
Which conducts heat better, Iron or Steel AISI 4340?
Iron conducts heat better: 73.2 W/m·K against 37.5 W/m·K for Steel AISI 4340.
Which expands less with temperature?
Steel AISI 4340 expands less: 11.3 µm/m·K against 13.7 µm/m·K for Iron.