Thermal conductivity against densityHigher and further left: spreads more heat for its weightThermal expansion against thermal conductivityLower and further right: warps less when heated
Try it on a partA sample part to run stress or thermal on, free in your browser
Technical Bulletin ATS-129: Properties of Soda-Lime Silica Float Glass (2025)Pilkington North Americaarchived copyGlass · Ultimate tensile strength: typical mean surface tensile stress at fracture (MOR), 60 s load, weathered, 50% breakage probabilityGlass · Flexural strength: mean MOR (same value as tensile)Glass · Young's modulus (stiffness): typicalGlass · Density: typicalGlass · Poisson's ratio: typicalGlass · Thermal conductivity: typical at 75 FGlass · Thermal expansion: typical, 75-575 FGlass · Specific heat: typical at 75 FGlass · Max service temperature: strain point (ASTM C336) - stress-relaxation onset, not a rated service limit
3
Luran S 777K (ASA) Product Data SheetINEOS StyrolutionFDM ASA · Thermal conductivity: base material: INEOS Styrolution Luran S 777K injection-molding ASA, typicalFDM ASA · Thermal expansion: base material: INEOS Styrolution Luran S 777K injection-molding ASA, range
Each number points to the document that states it, with the exact basis. Values without a number are computed from the sourced ones. "Not sourced" means no citable source states it (or only a specification minimum); figures computed from it are left out too.
FDM ASA is 3D printed: its properties depend on build direction and print settings; these are typical values.
Questions
Mechanical
Is FDM ASA stronger than Glass?
Glass is stronger: its tensile strength is 41 MPa against 37 MPa for FDM ASA (11%).
Which is lighter, FDM ASA or Glass?
FDM ASA is lighter: 1,050 kg/m³ against 2,500 kg/m³ for Glass.
Which is stiffer, FDM ASA or Glass?
Glass is stiffer: Young's modulus 72 GPa against 2.45 GPa for FDM ASA, so the same part in Glass deflects less under the same load.
Which is lighter for the same job, FDM ASA or Glass?
For the same stiffness or strength: FDM ASA is lighter for a strong rod or tie, strong beam, strong panel or plate; Glass is lighter for a stiff rod or tie (tension), stiff beam (bending), stiff panel or plate.
Part that must be
FDM ASA
Glass
Stiff rod or tie (tension)
12.3x heavier
lighter
Stiff beam (bending)
2.28x heavier
lighter
Stiff panel or plate
30% heavier
lighter
Strong rod or tie
lighter
2.15x heavier
Strong beam
lighter
2.22x heavier
Strong panel or plate
lighter
2.26x heavier
For the same stiffness or strength, mass scales with density over stiffness (or strength) raised to a power set by how the part is loaded: 1 for a rod in tension, 1/2 for a beam in bending, 1/3 for a panel (the standard material-selection indices).
Thermal
Which conducts heat better, FDM ASA or Glass?
Glass conducts heat better: 0.937 W/m·K against 0.17 W/m·K for FDM ASA.
Which expands less with temperature?
Glass expands less: 8.3 µm/m·K against 95 µm/m·K for FDM ASA.