Templates
Start from a working design.
Open a real, editable model, tweak the parameters, and run the physics. No blank canvas.
Robotics
Robotic arm gripper
A parametric two-finger gripper. Adjust the jaw and run stress on the pivot.
Open in editor →Drones
Quadcopter frame
A lightweight arm frame. Tune wall thickness and check modal frequencies.
Open in editor →Thermal
Heat sink
A finned heat sink. Change fin count and solve the steady-state temperature.
Open in editor →Structural
Mounting bracket
An L-bracket under load. Vary the fillet and watch the stress concentration.
Open in editor →Mechanisms
Planetary gear set
A parametric planetary gear. Change the ratio and see the assembly update.
Open in editor →Enclosures
Electronics enclosure
A snap-fit enclosure. Resize to your board and export a printable STL.
Open in editor →