Thermal conductivity against densityHigher and further left: spreads more heat for its weightThermal expansion against thermal conductivityLower and further right: warps less when heated
Try it on a partA sample part to run stress or thermal on, free in your browser
Technical Bulletin ATS-129: Properties of Soda-Lime Silica Float Glass (2025)Pilkington North Americaarchived copyGlass · Ultimate tensile strength: typical mean surface tensile stress at fracture (MOR), 60 s load, weathered, 50% breakage probabilityGlass · Flexural strength: mean MOR (same value as tensile)Glass · Young's modulus (stiffness): typicalGlass · Density: typicalGlass · Poisson's ratio: typicalGlass · Thermal conductivity: typical at 75 FGlass · Thermal expansion: typical, 75-575 FGlass · Specific heat: typical at 75 FGlass · Max service temperature: strain point (ASTM C336) - stress-relaxation onset, not a rated service limit
3
Zinc Die Casting Properties Guide (2012)Eastern AlloysZinc Zamak 3 · Poisson's ratio: typical, Zamak 3 hot-chamber die cast
Each number points to the document that states it, with the exact basis. Values without a number are computed from the sourced ones. "Not sourced" means no citable source states it (or only a specification minimum); figures computed from it are left out too.
Questions
Mechanical
Is Glass stronger than Zinc Zamak 3?
Zinc Zamak 3 is stronger: its yield strength is 221 MPa against tensile strength 41 MPa for Glass (5.39x).
Which is lighter, Glass or Zinc Zamak 3?
Glass is lighter: 2,500 kg/m³ against 6,600 kg/m³ for Zinc Zamak 3.
Which is stiffer, Glass or Zinc Zamak 3?
Zinc Zamak 3 is stiffer: Young's modulus 85.5 GPa against 72 GPa for Glass, so the same part in Zinc Zamak 3 deflects less under the same load.
Which is lighter for the same job, Glass or Zinc Zamak 3?
For the same stiffness or strength: Glass is lighter for a stiff rod or tie (tension), stiff beam (bending), stiff panel or plate, strong panel or plate; Zinc Zamak 3 is lighter for a strong rod or tie, strong beam.
Part that must be
Glass
Zinc Zamak 3
Stiff rod or tie (tension)
lighter
2.22x heavier
Stiff beam (bending)
lighter
2.42x heavier
Stiff panel or plate
lighter
2.49x heavier
Strong rod or tie
2.04x heavier
lighter
Strong beam
16% heavier
lighter
Strong panel or plate
lighter
14% heavier
For the same stiffness or strength, mass scales with density over stiffness (or strength) raised to a power set by how the part is loaded: 1 for a rod in tension, 1/2 for a beam in bending, 1/3 for a panel (the standard material-selection indices).
Thermal
Which conducts heat better, Glass or Zinc Zamak 3?
Zinc Zamak 3 conducts heat better: 113 W/m·K against 0.937 W/m·K for Glass.
Which expands less with temperature?
Glass expands less: 8.3 µm/m·K against 27.4 µm/m·K for Zinc Zamak 3.