Thermal conductivity against densityHigher and further left: spreads more heat for its weightThermal expansion against thermal conductivityLower and further right: warps less when heated
Try it on a partA bracket to run stress or thermal on, free in your browser
Wood Handbook (FPL-GTR-282), Chapter 5: Mechanical Properties of WoodUSDA Forest Products LaboratoryWood · Ultimate tensile strength: modulus of rupture (no direct tensile value)Wood · Compressive strength: compression parallel to grain (maximum crushing strength), 12% MCWood · Flexural strength: modulus of rupture (static bending), 12% MCWood · Young's modulus (stiffness): bending MOE, parallel to grainWood · Poisson's ratio: mu_LR (red oak group, ~12% MC)
3
Technical Note 218: Weights of Various Woods Grown in the United States (1953)USDA Forest Products LaboratoryWood · Density: average weight of clear wood at 8% and 15% moisture content
4
Zinc Die Casting Properties Guide (2012)Eastern AlloysZinc Zamak 3 · Poisson's ratio: typical, Zamak 3 hot-chamber die cast
5
Wood Handbook (FPL-GTR-282), Chapter 4: Moisture Relations and Physical Properties of WoodUSDA Forest Products LaboratoryWood · Thermal conductivity: across grain, 12% MC (Table 4-7, approximate)Wood · Thermal expansion: parallel to grain, ovendry wood, range across speciesWood · Specific heat: solid wood (all species), 12% MC, 27 C
Each number points to the document that states it, with the exact basis. Values without a number are computed from the sourced ones. "Not sourced" means no citable source states it (or only a specification minimum); figures computed from it are left out too.
Questions
Mechanical
Is Wood stronger than Zinc Zamak 3?
Zinc Zamak 3 is stronger: its yield strength is 221 MPa against tensile strength 99 MPa for Wood (2.23x).
Which is lighter, Wood or Zinc Zamak 3?
Wood is lighter: 692 kg/m³ against 6,600 kg/m³ for Zinc Zamak 3.
Which is stiffer, Wood or Zinc Zamak 3?
Zinc Zamak 3 is stiffer: Young's modulus 85.5 GPa against 12.5 GPa for Wood, so the same part in Zinc Zamak 3 deflects less under the same load.
Which is lighter for the same job, Wood or Zinc Zamak 3?
For the same stiffness or strength: Wood is lighter for a stiff rod or tie (tension), stiff beam (bending), stiff panel or plate, strong rod or tie, strong beam, strong panel or plate.
Part that must be
Wood
Zinc Zamak 3
Stiff rod or tie (tension)
lighter
40% heavier
Stiff beam (bending)
lighter
3.65x heavier
Stiff panel or plate
lighter
5.03x heavier
Strong rod or tie
lighter
4.28x heavier
Strong beam
lighter
5.59x heavier
Strong panel or plate
lighter
6.39x heavier
For the same stiffness or strength, mass scales with density over stiffness (or strength) raised to a power set by how the part is loaded: 1 for a rod in tension, 1/2 for a beam in bending, 1/3 for a panel (the standard material-selection indices).
Thermal
Which conducts heat better, Wood or Zinc Zamak 3?
Zinc Zamak 3 conducts heat better: 113 W/m·K against 0.18 W/m·K for Wood.
Which expands less with temperature?
Wood expands less: 3.8 µm/m·K against 27.4 µm/m·K for Zinc Zamak 3.