Thermal conductivity against densityHigher and further left: spreads more heat for its weightThermal expansion against thermal conductivityLower and further right: warps less when heated
Try it on a partA bracket to run stress or thermal on, free in your browser
PLEXIGLAS GS and XT Technical Information (Ref. No. 211-1)Röhmarchived copyPlastic PMMA · Ultimate tensile strength: typical, 23 °CPlastic PMMA · Compressive strength: compressive yield stress, typicalPlastic PMMA · Flexural strength: typicalPlastic PMMA · Elongation at break: typicalPlastic PMMA · Young's modulus (stiffness): typical, short-termPlastic PMMA · Density: typicalPlastic PMMA · Poisson's ratio: typicalPlastic PMMA · Thermal conductivity: typicalPlastic PMMA · Thermal expansion: 0-50 °CPlastic PMMA · Specific heat: typicalPlastic PMMA · Max service temperature: max. permanent service temperature
3
Wieland-K32 (Cu-ETP, C11000) Data SheetWielandarchived copyCopper C110 · Poisson's ratio: reference value at room temperature (Wieland-K32 = Cu-ETP = C11000, rolled products)
Each number points to the document that states it, with the exact basis. Values without a number are computed from the sourced ones. "Not sourced" means no citable source states it (or only a specification minimum); figures computed from it are left out too.
Questions
Mechanical
Is Copper C110 stronger than Plastic PMMA?
Plastic PMMA is stronger: its tensile strength is 80 MPa against yield strength 69 MPa for Copper C110 (16%).
Which is lighter, Copper C110 or Plastic PMMA?
Plastic PMMA is lighter: 1,190 kg/m³ against 8,913 kg/m³ for Copper C110.
Which is stiffer, Copper C110 or Plastic PMMA?
Copper C110 is stiffer: Young's modulus 117 GPa against 3.3 GPa for Plastic PMMA, so the same part in Copper C110 deflects less under the same load.
Which is lighter for the same job, Copper C110 or Plastic PMMA?
For the same stiffness or strength: Copper C110 is lighter for a stiff rod or tie (tension); Plastic PMMA is lighter for a stiff beam (bending), stiff panel or plate, strong rod or tie, strong beam, strong panel or plate.
Part that must be
Copper C110
Plastic PMMA
Stiff rod or tie (tension)
lighter
4.74x heavier
Stiff beam (bending)
26% heavier
lighter
Stiff panel or plate
2.28x heavier
lighter
Strong rod or tie
8.68x heavier
lighter
Strong beam
8.27x heavier
lighter
Strong panel or plate
8.06x heavier
lighter
For the same stiffness or strength, mass scales with density over stiffness (or strength) raised to a power set by how the part is loaded: 1 for a rod in tension, 1/2 for a beam in bending, 1/3 for a panel (the standard material-selection indices).
Which is more ductile, Copper C110 or Plastic PMMA?
Copper C110 stretches further before it breaks: 55% elongation at break against 5.5% for Plastic PMMA.
Thermal
Which conducts heat better, Copper C110 or Plastic PMMA?
Copper C110 conducts heat better: 391 W/m·K against 0.19 W/m·K for Plastic PMMA.
Which expands less with temperature?
Copper C110 expands less: 16.9 µm/m·K against 70 µm/m·K for Plastic PMMA.