Thermal conductivity against densityHigher and further left: spreads more heat for its weightThermal expansion against thermal conductivityLower and further right: warps less when heated
Try it on a partA sample part to run stress or thermal on, free in your browser
Technical Bulletin ATS-129: Properties of Soda-Lime Silica Float Glass (2025)Pilkington North Americaarchived copyGlass · Ultimate tensile strength: typical mean surface tensile stress at fracture (MOR), 60 s load, weathered, 50% breakage probabilityGlass · Flexural strength: mean MOR (same value as tensile)Glass · Young's modulus (stiffness): typicalGlass · Density: typicalGlass · Poisson's ratio: typicalGlass · Thermal conductivity: typical at 75 FGlass · Thermal expansion: typical, 75-575 FGlass · Specific heat: typical at 75 FGlass · Max service temperature: strain point (ASTM C336) - stress-relaxation onset, not a rated service limit
3
Eastar Copolyester 6763 Product Data SheetEastmanPlastic PETG · Thermal conductivity: base material: Eastman Eastar Copolyester 6763 (PETG), typicalPlastic PETG · Thermal expansion: base material: Eastman Eastar Copolyester 6763 (PETG), typicalPlastic PETG · Specific heat: base material: Eastman Eastar Copolyester 6763 (PETG), DSC at 60 °C (lowest temperature listed)
Each number points to the document that states it, with the exact basis. Values without a number are computed from the sourced ones. "Not sourced" means no citable source states it (or only a specification minimum); figures computed from it are left out too.
Plastic PETG is 3D printed: its properties depend on build direction and print settings; these are typical values.
Questions
Mechanical
Is Glass stronger than Plastic PETG?
Plastic PETG is stronger: its yield strength is 46.2 MPa against tensile strength 41 MPa for Glass (13%).
Which is lighter, Glass or Plastic PETG?
Plastic PETG is lighter: 1,270 kg/m³ against 2,500 kg/m³ for Glass.
Which is stiffer, Glass or Plastic PETG?
Glass is stiffer: Young's modulus 72 GPa against 1.94 GPa for Plastic PETG, so the same part in Glass deflects less under the same load.
Which is lighter for the same job, Glass or Plastic PETG?
For the same stiffness or strength: Glass is lighter for a stiff rod or tie (tension), stiff beam (bending), stiff panel or plate; Plastic PETG is lighter for a strong rod or tie, strong beam, strong panel or plate.
Part that must be
Glass
Plastic PETG
Stiff rod or tie (tension)
lighter
18.9x heavier
Stiff beam (bending)
lighter
3.1x heavier
Stiff panel or plate
lighter
1.69x heavier
Strong rod or tie
2.22x heavier
lighter
Strong beam
2.13x heavier
lighter
Strong panel or plate
2.09x heavier
lighter
For the same stiffness or strength, mass scales with density over stiffness (or strength) raised to a power set by how the part is loaded: 1 for a rod in tension, 1/2 for a beam in bending, 1/3 for a panel (the standard material-selection indices).
Thermal
Which conducts heat better, Glass or Plastic PETG?
Glass conducts heat better: 0.937 W/m·K against 0.21 W/m·K for Plastic PETG.
Which expands less with temperature?
Glass expands less: 8.3 µm/m·K against 51 µm/m·K for Plastic PETG.