Thermal conductivity against densityHigher and further left: spreads more heat for its weightThermal expansion against thermal conductivityLower and further right: warps less when heated
Try it on a partA bracket to run stress or thermal on, free in your browser
Typical Engineering Properties of High Density PolyethyleneINEOS Olefins & Polymers USAarchived copyPlastic HDPE · Poisson's ratio: base material: high-density polyethylene family (INEOS Olefins & Polymers USA, Typical Engineering Properties of HDPE)Plastic HDPE · Thermal conductivity: base material: high-density polyethylene family (INEOS Olefins & Polymers USA, Typical Engineering Properties of HDPE)Plastic HDPE · Thermal expansion: base material: high-density polyethylene family (INEOS Olefins & Polymers USA, Typical Engineering Properties of HDPE)Plastic HDPE · Specific heat: base material: high-density polyethylene family (INEOS Olefins & Polymers USA, Typical Engineering Properties of HDPE)
4
Zinc Die Casting Properties Guide (2012)Eastern AlloysZinc Zamak 3 · Poisson's ratio: typical, Zamak 3 hot-chamber die cast
Each number points to the document that states it, with the exact basis. Values without a number are computed from the sourced ones. "Not sourced" means no citable source states it (or only a specification minimum); figures computed from it are left out too.
Questions
Mechanical
Is Plastic HDPE stronger than Zinc Zamak 3?
Zinc Zamak 3 is stronger: its yield strength is 221 MPa against 24 MPa for Plastic HDPE (9.21x).
Which is lighter, Plastic HDPE or Zinc Zamak 3?
Plastic HDPE is lighter: 950 kg/m³ against 6,600 kg/m³ for Zinc Zamak 3.
Which is stiffer, Plastic HDPE or Zinc Zamak 3?
Zinc Zamak 3 is stiffer: Young's modulus 85.5 GPa against 0.9 GPa for Plastic HDPE, so the same part in Zinc Zamak 3 deflects less under the same load.
Which is lighter for the same job, Plastic HDPE or Zinc Zamak 3?
For the same stiffness or strength: Plastic HDPE is lighter for a stiff panel or plate, strong beam, strong panel or plate; Zinc Zamak 3 is lighter for a stiff rod or tie (tension), stiff beam (bending), strong rod or tie.
Part that must be
Plastic HDPE
Zinc Zamak 3
Stiff rod or tie (tension)
13.7x heavier
lighter
Stiff beam (bending)
40% heavier
lighter
Stiff panel or plate
lighter
1.52x heavier
Strong rod or tie
33% heavier
lighter
Strong beam
lighter
1.58x heavier
Strong panel or plate
lighter
2.29x heavier
For the same stiffness or strength, mass scales with density over stiffness (or strength) raised to a power set by how the part is loaded: 1 for a rod in tension, 1/2 for a beam in bending, 1/3 for a panel (the standard material-selection indices).
Thermal
Which conducts heat better, Plastic HDPE or Zinc Zamak 3?
Zinc Zamak 3 conducts heat better: 113 W/m·K against 0.445 W/m·K for Plastic HDPE.
Which expands less with temperature?
Zinc Zamak 3 expands less: 27.4 µm/m·K against 120 µm/m·K for Plastic HDPE.