BASF Ultradur B 4300 G6 (PBT, 30% glass fibre), injection moulding grade; product information sheet 09/2026, typical values for uncoloured product at 23 °C.
Röhm PLEXIGLAS GS 0F00 cast acrylic sheet, typical values at 23 °C / 50 % RH (Röhm Technical Information Ref. No. 211-1)
Every value links to the document that states it. "Not sourced" means no citable source states it (or only a specification minimum); figures computed from it are left out too.
Questions
Is Plastic PBT GF30 stronger than Plastic PMMA?
Plastic PBT GF30 is stronger: its tensile strength is 140 MPa against 80 MPa for Plastic PMMA (1.75x).
Which is lighter, Plastic PBT GF30 or Plastic PMMA?
Plastic PMMA is lighter: 1,190 kg/m³ against 1,530 kg/m³ for Plastic PBT GF30.
Which is stiffer, Plastic PBT GF30 or Plastic PMMA?
Plastic PBT GF30 is stiffer: Young's modulus 9.8 GPa against 3.3 GPa for Plastic PMMA, so the same part in Plastic PBT GF30 deflects less under the same load.
Which is lighter for the same job, Plastic PBT GF30 or Plastic PMMA?
For the same stiffness or strength: Plastic PBT GF30 is lighter for a stiff rod or tie (tension), stiff beam (bending), stiff panel or plate, strong rod or tie, strong beam, strong panel or plate.
Part that must be
Plastic PBT GF30
Plastic PMMA
Stiff rod or tie (tension)
lighter
2.31x heavier
Stiff beam (bending)
lighter
34% heavier
Stiff panel or plate
lighter
12% heavier
Strong rod or tie
lighter
36% heavier
Strong beam
lighter
13% heavier
Strong panel or plate
lighter
3% heavier
For the same stiffness or strength, mass scales with density over stiffness (or strength) raised to a power set by how the part is loaded: 1 for a rod in tension, 1/2 for a beam in bending, 1/3 for a panel (the standard material-selection indices).
Which conducts heat better, Plastic PBT GF30 or Plastic PMMA?
Plastic PBT GF30 conducts heat better: 0.27 W/m·K against 0.19 W/m·K for Plastic PMMA.
Which expands less with temperature?
Plastic PBT GF30 expands less: 25 µm/m·K against 70 µm/m·K for Plastic PMMA.