Thermal conductivity against densityHigher and further left: spreads more heat for its weightThermal expansion against thermal conductivityLower and further right: warps less when heated
Try it on a partA bracket to run stress or thermal on, free in your browser
Sources5 documents: Nathan Trotter, Weir Minerals, National Institute of Standards and Technology, Eastern Alloys, Defense Technical Information Center
Linatex Premium Rubber Spec Sheet (WMD0118, 2023)Weir MineralsRubber · Ultimate tensile strength: typicalRubber · Elongation at break: typicalRubber · Density: typical (specific gravity)Rubber · Max service temperature: continuous use operating range
3
Compressibility of Natural Rubber at Pressures Below 500 kg/cm², J. Res. NBS 68A (1964)National Institute of Standards and Technologyarchived copyRubber · Poisson's ratio: government (NBS J. Res. 68A, 1964): computed by NBS for peroxide-cured gum NR vulcanizate, 25 °C, infinitesimal deformation (0.49 in the solver: the linear element locks as the ratio nears 0.5 (nearly incompressible).)Rubber · Specific heat: government (NBS J. Res. 68A, Table 7; values observed for unvulcanized NR by Bekkedahl and Matheson), 25 °C
4
Zinc Die Casting Properties Guide (2012)Eastern AlloysZinc Zamak 3 · Poisson's ratio: typical, Zamak 3 hot-chamber die cast
5
Thermal Conductivity of Soft Vulcanized Natural Rubber: Selected Values (AD 643325)Defense Technical Information Centerarchived copyRubber · Thermal conductivity: government selected value (US Army Natick Laboratories TR 66-49-PR, 1966), soft vulcanized natural rubber, 25 °C
Each number points to the document that states it, with the exact basis. Values without a number are computed from the sourced ones. "Not sourced" means no citable source states it (or only a specification minimum); figures computed from it are left out too.
Questions
Mechanical
Is Rubber stronger than Zinc Zamak 3?
Zinc Zamak 3 is stronger: its yield strength is 221 MPa against tensile strength 23 MPa for Rubber (9.61x).
Which is lighter, Rubber or Zinc Zamak 3?
Rubber is lighter: 960 kg/m³ against 6,600 kg/m³ for Zinc Zamak 3.
Which is lighter for the same job, Rubber or Zinc Zamak 3?
For the same stiffness or strength: Rubber is lighter for a strong beam, strong panel or plate; Zinc Zamak 3 is lighter for a strong rod or tie.
Part that must be
Rubber
Zinc Zamak 3
Strong rod or tie
40% heavier
lighter
Strong beam
lighter
1.52x heavier
Strong panel or plate
lighter
2.22x heavier
For the same stiffness or strength, mass scales with density over stiffness (or strength) raised to a power set by how the part is loaded: 1 for a rod in tension, 1/2 for a beam in bending, 1/3 for a panel (the standard material-selection indices).
Which is more ductile, Rubber or Zinc Zamak 3?
Rubber stretches further before it breaks: 830% elongation at break against 10% for Zinc Zamak 3.
Thermal
Which conducts heat better, Rubber or Zinc Zamak 3?
Zinc Zamak 3 conducts heat better: 113 W/m·K against 0.151 W/m·K for Rubber.